|
|
#11
03-01-2010, 10:21 PM
|
|||
|
|||
|
LLY Injectors are much different than LB7 injectors.
Stock LB7s have supported over 700hp on numerous occasions. I would just leave them alone and do them at the same time as you build your motor. There isnt much use for them without a built motor, yes its nice to lower the pulse width, but IMO its not worth the 10 hours of labor, down time and cost to get them done and then do it all over again. Typical extrude honing WITH balancing will be around $1000 give or take. 
|
|
#13
03-02-2010, 08:43 PM
|
||||
|
||||
|
Another new guy. WOW we are exploding. Welcom to the site.
__________________
Real racers go striaght to the finish line, the other guys go around in circles trying to find it. 612-961-3187
|
|
#14
03-02-2010, 08:44 PM
|
||||
|
||||
|
Quote:
__________________
1996 RED Ram, 2WD, GOERENDS Auto, timing at 16.5*, #100 plate, 300 Injectors, 365hp 833tq, 28' Dutchmen fifth wheel, and a 16' boat behind that!
|
 |
| Bookmarks |
| Thread Tools | |
|
|
